NO. | Problem | Methods |
1 | Bell type | Change belt |
2 | The rectifying device is not working normally. The sand belt moves slowly to one side and quickly to the other | Adjust the rectifying device |
3 | The edge of the sand belt jumps too much, resulting in the failure of the rectifying device (the S-side flapping edge of the sand belt) | Use large sand belt tension, if the edge continues to beat need to replace the sand belt |
4 | Jet tracking failure, dirt or other debris plug air nozzle | Check air pipeline and joint for leakage: keep air nozzle open, install air static purifier, purify air |
5 | The belt tension is too small, causing skidding and deflecting the belt | Increase the load |
6 | Contact roller is conical | remove cone |
7 | Photoelectric device does not work | often use soft cloth or alcohol to wipe the winning air nozzle against the photoelectric device or reflector, replace if necessary |
8 | Contact wheel, support wheel surface wear or rubber stripping. | Trim or replace |
9 | Uneven belt application, concentrated grinding. | Use the entire surface evenly |
ADD:
No. 1003 Building 9, Henan E-commerce Industrial Park, High-tech Zone, Zhongyuan District, Zhengzhou, ChinaTEL/FAX:
+8619937510087WhatsApp:
+8619937510087Email:
info@yihongabrasives.com
Wechat Service