Flap disc is suitable for polishing stainless steel, metal, metallurgy, automobile, wood, marble and other industries, also belongs to a kind of industrial consumables products.Impeller matrix with mesh, nylon, plastic, steel paper, etc., the number of pages are different, uniform fan distribution.flap disc is especially suitable for stainless steel processing, can replace resin sequence sand wheel, it has a strong elasticity, high tensile bending strength, good self-sharpening, high grinding rate, low noise, suitable for box body welding seam send stamping flash grinding.

One, the right choice

The correct selection of 100 flaps can ensure that 100 flaps are maximized. The cutting force of a hundred impellers with good quality is relatively strong, which can adapt to the cutting treatment of materials with different strength. Its heat-resistant and wear-resistant characteristics can also finish large-scale equipment grinding and polishing, with strong hardness and service life is up to several times more than similar cutting products.

Two, enough pressure

Overuse can overload and overheat the blades, which can lead to faster blade wear and reduce the effectiveness of abrasives. At the same time, if there is not enough pressure to use, flap disc will not engage with the metal, not enough to effectively grind the surface, which will lead to longer grinding time and further wear.

Three, the correct use

Flap disc are designed to work at an Angle grinder. The Angle depends on what you're making and what you're grinding, however, generally in the flat/horizontal range of 5-10 degrees. If the Angle is too flat, too many flap grain will immediately connect to the metal, causing flap disc to wear out faster. If the Angle is too high, the flaps cannot be fully used. This will lead to excessive wear on some of the 100 flaps and insufficient polishing.